Housing for interior installation of standard devices, built as a modular system conforming to standards.

	Device racks made of: rolled galvanised steel sections aluminium die-cast corner connectors (optionally with or without M20 thread for lifting eyes) or plastic corner connectors (black)
	Panels double shelled, 60mm thick, made of galvanised steel sheet
	Sheet thickness: 1.00 mm - 1.25 mm (depending on size of unit)
	Insulation of incombustible, noise- and heat-blocking rock wool mats horizontally oriented, glued on both sides; density 33 kg/m³

Airbox sizes: S60-07Q to S60-28R (standard profile)
Airbox sizes: I60-07Q to I60-28R (thermal insulated)

Air conditioning unit and ventilation equipment is built according to the kit principle and can be produced in any desired combination.

The corner section is sealed to the die-cast corner connector with an EPDM seal.
Side panels are double-walled, made of galvanised sheet steel with incombustible noise- and heat-blocking inner sheathing made of rock wool mats according to DIN 4102 A1. For hygienic equipment, the inner panels can be furnished in stainless steel. A coloured plastic coating of the panel and frame (RAL 7035) is also available.

Wall thickness 60 mm
Insulation rating K = 0.54 W/m2K
Thermal bridge factor Kb (S60)= 0.55 (TB3)
Thermal bridge factor Kb (I60)= 0.65 (TB2)


Einfügedämmaß De [dB] according to EN 13053 for 1 mm inner and outer sheet thickness.

Panels are screwed to the section chamber, so that no fixing elements protrude into the device. Thus the interiors of the devices are completely smooth. Modules are attached with connection plates at the corners.

If desired, housings can be made to be fully disassembled.

Air volume: 2.200 - 84.500 m³/h